What checks need to be done before the stepper motor is powered on - Database & Sql Blog Articles

Single chip microcomputer STM32L151CCU6

SMD aluminum electrolytic capacitor

MOS power IC full range

Photocoupler

Before the stepper motor is powered on, check the following:

1) Is the power supply voltage suitable (overvoltage is likely to cause damage to the drive module); the +/- polarity of the DC input must not be connected incorrectly, and the motor model or current setting value on the drive controller is appropriate (do not start at the beginning) Too big);

2) The control signal line is firmly connected, and the industrial site should preferably consider the shielding problem (such as using twisted pair);

3) Do not connect the wires that need to be connected at the beginning, only connect to the most basic system. After running well, connect them step by step.

4) Be sure to find out the grounding method, or use the floating.

5) Closely observe the state of the motor within half an hour of starting operation, such as whether the motion is normal, sound and temperature rise, and immediately stop the adjustment after finding the problem.