Commissioning after CNC machine tool repair - Solutions - Huaqiang

Probe domestic switch needle KG-300K needle head diameter is 3.0mm normally open switch needle

Single chip microcomputer STM32L151CCU6

Mobile phone crystal 3.2*2.5mm 3225 26M (26.000MHZ) 7.5PF 10PPM 20PPM 30PPM

Test - lowercase jpg

After the troubleshooting of the machine tool, the power test is usually carried out in two major steps:
1. The automatic state test locks the machine tool, performs the dry running test with the programmed program, verifies the correctness of the program, and then releases the machine tool, and respectively performs the feedrate override switch, the fast overrun switch, and the spindle speed overshoot switch. The change causes the machine to fully operate under the various changes of the above switches, and then the overshoot switches are placed at 100% to fully operate the machine and observe whether the working condition of the whole machine is normal.
2. Normal processing test The workpiece is clamped and processed according to the normal procedure. After processing, the machining accuracy of the workpiece is checked to meet the standard requirements.